Jobs yet to do Wilson 8m

The items below are to give you a general overview of the jobs yet to do on the boat.
I'm taking this from the expected stage we should attain by the end of this week.
The list therefore is from your fist day back after the midterm break.
We do not have a 'work experience week' available, so return to Unitec will be the 24th October.


In general, the below jobs already have set to be done by certain students.
it is obvious that each of these topics and 'jobs to be done' are more complicated than the short description outlined here.
It is incumbent on each student to identify the more detailed events around each job and acknowledge the learning these jobs have promoted by writing it up. E.g. Blogs, portfolios, Collaborative google-docs, etc...


Deck/Cabins:

fairing of all foam cores fitted to date.
Insert edging pieces and manually fit..
Inner laminate for the side decks.
Cores vacuum bagged for the side decks.
Side deck foam cores faired.
Cabin top outer laminates. This includes extra laminates to produce a flange for the window rebates.
Foredeck outer laminates.
side decks outer laminates.
Filling and fairing entire outside surfaces of deck and cabin tops. This includes replacing the window pattens to build an edge for fairing to the shape.
Trim accurate rebate window areas.
Temporary splashes (cradle) for the deck/cabin to sit in in the hotbox.
Removal of product from mould.
Placing in the hotbox for post curing.



Hull and interior:

Water tank area. hatches, Seacocks, water pipe run,
Head area doors, plinth, cabinet, fwd berth entrance trim, stiffener on fwd bulkhead.
cabinet top and basin.
Fuel tank fitted and held. Cabin sole glued in sheathed filled and faired.
Allowance for removable bottom of galley return piping etc...
galley bench sink fitting, cooker shelf and locker below. gas bottle shelf and outboard venturii vent.
Battery locker and seat plinth.
dropped sole over water piping, glued, sheathed and filled and faired.
Steering helm location and items.
hydraulic tubing ran, wiring loom run aft and to battery box.
access through bulkhead into head cabinet for hidden cabling.
Transducer fitted aft under engine locker,
Engine locker glassing and items fitted filled and faired.
coving all areas.
Aft boarding step and quarter badge.
Aft boarding door cutouts.
Fwd (anchor) bulkhead coved and glass taped with EDB430-100 tape. filled and faired.
Underside of gunwale small cove to tidy.


Hull /Deck joining:

Scribing bulkheads and fitting deck to the hull.

Gluing and fastening to the hull.

cleanup and coving inside join. Glass taping?

outboard gunwale toerail/belting?

General Filling, Fairing. undercoating (probably with roller sleeves)